-BME280 -inRH, inTemp, pressure -HYT221 -outRH, outTemp -ADS1115 (Analog Digital Converter) -Rain Gauge (on channel 0) -ABE Differential (ADC) -CGR3 -Temperature(8) -Long Wave Radiation(7) -Wind -Wind Direction (6) -Wind Speed (5) *Still working on this one -Apogee -Short Wave Radiation(4)
The ADC has an alert pin which can be toggled if a designated channel goes high Set channel where the rain bucket will be plugged into the ADS1115 Set GPIO pin where the pi will read the value of the toggle And make sure to start_toggle_watch(channel) at the beginning of the Main code
Apogee |Sensor |Connector
A0 |Green > Red 3.3V |White > Blu GND |Clear > Ylw
Wind |Sensor |Connector
3.3V |White >
Speed Sig |Red >
Speed Gnd |Blue >
Direction Sig |Green >
Direction Sig |Black >
CGR3 |Sensor |Connector
GND (THERM) |Green > White V-OUT (THERM) |Yellow > Yellow GND (PYRO) |Blue > Black V-OUT (PYRO) |Red > Red
BME280
3vol > 3v3
GND > GND
SCK > SCL
SDI > SDA