This package contains packaging wrappers around etcd that allow for easy installation, clustering and management of an etcd cluster.

Configuration for the clearwater-etcd cluster is done through the standard /etc/clearwater/local_config file, the following values must be provided:

• etcd_cluster - See below
• local_ip - The local IP address

You can also provide a etcd_key value. This controls what key is used to store the clustering and configuration values in etcd. It defaults to clearwater if it isn't set.

clearwater-etcd forms a cluster across your nodes to allow configuration to be easily shared. Most of the extra function added by the clearwater-etcd wrapper is to simplify the management of the cluster. The operations that can be performed are:

• Create a new cluster
• Join an existing cluster
• Decommission a node (remove it permanently from the cluster)

Creating a cluster is as easy as determining the list of nodes that will be in the cluster and populating the etcd_cluster configuration parameter with the comma-separated list of nodes:

etcd_cluster=10.0.0.1,10.0.0.2,10.0.0.3

When you now install clearwater-etcd on each of these nodes, the cluster will automatically form.

Joining an existing cluster requires determining the list of nodes that are currently in the cluster and providing that list in the etcd_cluster. Note that the newly added node MUST NOT be included in this list (otherwise we'll attempt to form the cluster from scratch).

To decommission a node run sudo service clearwater-etcd decommission which will gracefully remove the local node, stop the local etcd service and destroy the node's state. At this point, the etcd service can be re-attached to that (or another) etcd cluster by updating etcd_cluster and starting the clearwater-etcd service.

• etcd and etcdctl are the versions downloaded from https://github.com/coreos/etcd/releases/download/v2.2.5/etcd-v2.2.5-linux-amd64.tar.gz
• etcd-dump-logs is built from https://github.com/coreos/etcd/blob/v2.2.5/tools/etcd-dump-logs/main.go