Raspberry Pi Domotica Server

README is a work-in-(slow)-progress :D

Todo

• Usage
• Hardware wiring
• protocol
• Tests
• Modules
• Configuration

• Raspberry Pi computer running Raspbian

  • Python 2.7
  • Wiring Pi

• Python modules:

  • Serial (python-serial)
  • RPi.GPIO (python-rpi.gpio)
  • SMBus (python-smbus)
  • sudo apt-get install python-serial python-rpi.gpio python-smbus

@todo: Clone from github

@todo: Look at server/DomoServer.cfg and client/client.cfg.

$ python server/DomoServer.py &

This should run a server, on the port configured in DomoServer.cfg

@todo: Look at client/client.cfg.

Send KAKU on / off commands to old and new Klik Aan Klik Uit (KAKU) receivers.

• RF 434 Mhz transmitter (i use: https://www.iprototype.nl/products/components/communications/rf-transmitter-434mhz)

Message: kaku:[house]:[device]:[state]

Possible values for:

• house: A,B,C,D,E,F,G,H,I,J,K,L,M,N,O or P
• device: 1,2,3,4,5,6,7,8,9,10,11,12,13,14,15 or 16
• state: on or off

• Adafruit 16-Channel 12-bit PWM/Servo Driver - I2C interface - PCA9685
• electronic circuit to upgrade the 5v low-watts PWM to 12V high-watts

Message: rgb:[channel]:value

Possible values for:

• channel: 0 to 15
• value: 0 (off) to 255 (on)

Thanx goto to Adafruit for having great products and even better learning system and open source code.