Perform the build. The output file will be stored at output/uart1_alt2_RILEYLINK/uart1_alt2_RILEYLINK.hex

make -f Makefile.uart1_alt2

Perform the install:

make -f Makefile.uart1_alt2 install

UART/SPI pins exposed on cc1110 debug header:

PIN - SPI_alt2 / UART1_alt2
P1.4 - CT / SSN
P1.5 - RT / SCK
P1.6 - TX / MOSI
P1.7 - RX / MISO

Perform the build. The output file will be stored at output/uart0_alt1_SRF_ERF/uart0_alt1_SRF_ERF.hex

make -f Makefile.uart0_alt1 BOARD_TYPE=SRF_ERF

Installation is bit more complicated, as you will need to attach connectors to the SRF pins manually (you can't use the wiring points on the board itself).

This XRF blog post maps cc-debugger connector to the XRF pin names.

However, the XRF pins are not the same as the SRF pin locations. For that, you can use the SRF OpenMicros Data to map things to the correct ERF locations.

• SRF Pin 5 - DDATA (also known as DD)
• SRF Pin 6 - DCLOCK (also known as DC)
• SRF Pin 9 - 3.3v (also known as VDD)
• SRF Pin 10 - Ground (also known as GND)
• SRF Pin 15 - Reset

To install the firmware:

make -f Makefile.uart0_alt1 BOARD_TYPE=SRF_ERF install