multicube.py is a program that displays a number of 
    cubes randomly distributed and rotated.  The display 
    has a number of keys enabled.
    The keys are as follows.
    a right
    s back
    d left
    w forward
    r up
    f down
    x reverse view.
    z reset view.
    Escape ends the program.
    Alt+Return sets full screen.
    Up arrow zooms in.
    Down arrow zooms out.
    
    To run the program you will need python 3.4 and the following libraries:
    PyOpenGL, PIL, numpy, sfml, and GLM. For the documenation I use epydoc.
    
    The installation command is:
    
    sudo chmod +x multicube.py
    sudo ./setup.py install
    
    To run a program use:
    
    multicube.py
    
    
    The documentation is located in:
    
    /usr/share/doc/multicube-doc
    
    The sources I used to educate myself concerning OpenGL are
    as follows:
        "OpenGL ES 3.0 Programming Guide Second Edition" 
    by Dan Ginsburg and Budirijanto Purnomo published by Addison-Wesley 2014.
        www.learnopengl.com.
    For python I used David Lutz' books from Oreilly Press.
    
    All of the software used is available at:
    www.pypi.org
    epydoc:  http://epydoc.sourceforge.net
    The program was written on debian linux available at:  www.debian.org.
    
    You can reach me at <eberdeed@eberdeed.net>.
    Updates will be available at www.eberdeed.net.
    Edward Charles Eberle 
    May 23rd, 2020 San Diego, California United States of America
    
    This program is licensed under the Lesser GNU Public license.
    It can be found in the assimpopengl/LGPL directory 
    and once installed it will be also found at 
    /usr/share/doc/multicube-doc/LGPL.  This 
    program is given as an instructional aid for learning
    and using the libraries presented and is not to 
    be considered fit for any particular use.