Welcome to the Liberthon Hackathon toolset created especially to provide you with P2P capabilities

You can deploy the P2P client in two ways:

• Compile spacemesh agent and run executable locally
• Build or use Spacemesh Docker image

Pre requisites: install the go framework

go get github.com/spacemeshos/go-spacemesh
cd ~/go/src/github/spacemeshos/go-spacemesh
git checkout -b hackathon
go build

Whether you are running the agent via Docker or Executable, This is how you can communicate and use the agent to build a P2P network.

In order for us to setup a P2P network we must first boot up a bootstrap node, This node will be one of the first nodes any client will connect to and allow nodes to discover new nodes in the network. to boot up a bootstrap node use:

./go-spacemesh

After a bootstrap node has been created, the other nodes can be booted and configured to connect to it. To specify a bootstrap when booting more nodes use the following command:

./go-spacemesh --bootstrap --bootnodes <BOOTSTRAP_IP>:<PORT<7513>>/<BOOTSTRAP_NODEID>

Note that you need to have the node ID in order to connect

docker run spaceanton/spacemesh:spacemesh_p2p

you can expose RPC port 9090 to control from host or integrate you executable to the docker image itself

After setting up your enviorment you can communicate with the p2p agent to send and receive messages.

In order to receive messages from the agent, a UDP por can be opened for listening to new messages. To open a UDP port a register command must be sent to the agent in the following manner:

curl -X POST -d '{ "name":"anton", "port":8081 }' 127.0.0.1:9090/v1/register

• name: The P2P inner protocol uses a protocol name to distinguish between messages of diffrent protocols.
• port: The port number on which data will be received (UDP)

After registering your protocol, raw messages can be received on the port. note: the data received is binary and needs to be parsed by your app according to your protocol.

Send a message to a specific P2P client

curl -X POST -d '{ "nodeID":"vx3xRTWPhSapZPB7oTCCD3J8hNrWzFmzQwnzut7BNLMV", "protocolName": "anton", "payload" : [0,10,10,10] }' 127.0.0.1:9090/v1/send

This call is similar to the brodcast call

• nodeID: ID of the receiver node

Messages can be sent throughout the network thru the gossip network, to send a message use the following call:

curl -X POST -d '{ "protocolName": "anton", "payload" : [0,10,10,10] }' 127.0.0.1:9090/v1/broadcast

• protocolName: protocol name that will be sent, receiveing clients will route the message according to this name
• payload: the payload (in bytes) that contains your application specific data.

the devnet is a simple python script used to spin up local docker containers to simulate a network. settings like size of the network and amount of connections each node holds are determined in the script code before running.

python devnet.py

This script tests a simple message broadcast but it can be extended to test much more than that.