An extendible client for using a Turn Touch with a Raspberry Pi. Comes with Hue, Nest and custom script support out of the box.

This code was written and tested with a Raspberry Pi Zero W.

Assuming python3 and pip3 are installed, install the following as root. Do not use a virtualenv!

sudo pip3 install gatt pyyaml apscheduler qhue python-nest
sudo apt-get install python3-dbus

Make sure your Turn Touch is disconnected and unpaired from any other devices, then run:

sudo gattctl --discover

You should see the Turn Touch come up and see its MAC Address, which will look similar to c2:51:f2:36:3f:ad.

Put this mac address in config.yml, and update any button press options you would like to configure - just enter any bash script to run.

Launch the listener with:

sudo python3 monitor.py

It should connect, and once it has you should be able to press buttons on your Turn Touch and see the output of your commands.

To see what controllers are available, run

sudo python3 monitor.py -l

To see help for setting up commands for a controller, run, e.g.

sudo python3 monitor.py -c hue

and then to set them up, run, e.g.

sudo python3 monitor.py -s hue

Most controllers that connect to a device will need some kind of setup. Controllers will often print out helpful information (such as available bulbs, thermostats) after setup.

The battery status is checked every hour. If you would like something to happen when it falls below a certain value, use the following:

battery_10: # will trigger when battery level falls to 10%
    type: bash
    command: email_me.sh

You probably want raspi-turntouch to run on boot. To do this, make sure the paths in turntouch.service are correct, then:

sudo cp turntouch.service /lib/systemd/system/turntouch.service
sudo systemctl daemon-reload
sudo systemctl start turntouch
sudo systemctl enable turntouch

You can see log output at /var/log/turntouch.log.

Make sure you have set up credentials for services such as Nest and Hue before doing this!

• Decide on a name for your controller. In this example it is custom. This key must be used in the filename and config.yml entries.
• Create controllers/custom_controller.py
• Create a class called, e.b. CustomController. It must inherit from BaseController.
• Implement perform(self, action), where action is a dict as passed from config.yml, and init for setup.
• In config.yml, simply address your controller as follows:

north_press:
    type: custom
    arg1: Whatever you want
    another_arg:
        - can
        - even
        - be
        - a
        - list

If your controller is used for a common action, service or product, consider submitting a pull request!