Python interface for GPIO keypads and APA102 RGB LEDs. Inspired by the Pimoroni Keybow.

If you're running a raspi, add the following in your /boot/config.txt if they're not there, and reboot:

dtparam=spi=on
dtoverlay=swc2

• Python 3
• SpiDev
• gpiozero
• RPi.GPIO

These can be installed on Raspberry Pi OS like this:

sudo apt install python3-spidev python3-gpiozero python3-rpi.gpio

As root:

./init-usb-gadget.sh
python3 njak.py

Currently a bit messy, you'll need to do all of this by hand.

• (optional) create descriptor/mac-host and descriptor/mac-dev containing the MAC addresses for the USB NIC.

• copy services\*.service to /etc/systemd/system

• edit both service files to point to the correct location

• enable and start the services:

  systemctl daemon-reload
  systemctl enable njak-usb-gadget.service
  systemctl start njak-usb-gadget.service
  systemctl enable njak.service
  systemctl start njak.service
  

• configure static USB Ethernet gadget IP

• setup dnsmasq for dhcp

• serial-getty on USB serial gadget

• systemd service for launching python script

The physical mapping is defined in the layout array in config.py. This is an array of 12 tuples of (led index, key gpio) and they're configured by default to match the Keybow (because that's what I'm working with).

9(0, 20)   A(4, 16)   B(8, 26)
6(1, 6)    7(5, 12)   8(9, 13)
3(2, 22)   4(6, 24)   5(A, 5)
0(3, 17)   1(7, 27)   2(B, 23)

The key mappings and other behaviours are specified in the constructor of the Njak class. This creates a number of handlers that get bound to the GPIO keys. The handlers must accept two arguments: the gpiozero Button instance and the njak Key object.

The Bitmap HID report contains a helper to generate handlers for key presses.

Key handlers are grouped into layers. Key 0 (bottom left on the Keybow) is reserved to switch between layers. Currently, layers are defined in a 2D array in the Njak constructor and passed into the Keypad class. It's a little broken but I'm working on it...

Switch between layers by holding key 0 and then pressing the key corresponding to the desired layer. The key representing the selected layer will go dark.

Default layers:

0. Keys 0 - 9 and enter
1. Every key is F13. I use it for Discord PTT :P

• Work out some new things to do with it :P
• Auto-type strings
• Multi-key sequences

TODO