pyblehci is a library, written in Python, that provides a combined parser-builder for TI vendor-specific HCI packets utilised by the HostTestRelease application.
>>> p = pyblehci.BLEParser()
>>> p._split_response("\\x04\\xFF\\x08\\x7F\\x06\\x00\\x31\\xFE\\x02\\xD0\\x07")
('\\x04\\xff\\x08\\x7f\\x06\\x00\\x31\\xfe\\x02\\xd0\\x07', OrderedDict(
[('type', ('\\x04', 'Event')),
('event_code', ('\\xff', 'HCI_LE_ExtEvent')),
('data_len', ('\\x02', '02')),
('event', ('\\x06\\x7f', 'GAP_HCI_ExtensionCommandStatus')),
('status', ('\\x00', '00')),
('op_code', ('\\31\\xfe', 'GAP_GetParam')),
('param_value', ('\\xd0\\x07', '07d0'))]))
>>> b = pyblehci.BLEBuilder()
>>> b._build_command("fe31", param_id="\x15")
('\\x01\\x31\\xfe\\x01\\x15', OrderedDict([
('type', ('\\x01', 'Command')),
('op_code', ('\\x31\\xfe', 'GAP_GetParam')),
('data_len', ('\\x01', '01')),
('param_id', ('\\x15', '15'))])
)
...pyblehci can also be used to read and write to the device found on the serial interface. The parser operates asynchronously via a callback method allowing asynchronous reading/writing of the device. This is possible by use of pySerial
>>> serial_port = serial.Serial(port='/dev/ttyACM0', baudrate=57600)
>>> def analyse_packet(packet):
... print packet
...
>>> p = pyblehci.BLEParser(serial_port, callback=analyse_packet)
>>> b = pyblehci.BLEBuilder(serial_port)
>>> b.send(cmd="fe31", param_id="\x15")
('\x011\xfe\x01\x15', OrderedDict([('type', ('\x01', 'Command')), ('op_code', ('
1\xfe', 'GAP_GetParam')), ('data_len', ('\x01', '01')), ('param_id', ('\x15', '1
5'))]))
('\x04\xff\x08\x7f\x06\x001\xfe\x02P\x00', OrderedDict([('type', ('\x04', 'E
vent')), ('event_code', ('\xff', 'HCI_LE_ExtEvent')), ('data_len', ('\x02', '02'
)), ('event', ('\x06\x7f', 'GAP_HCI_ExtensionCommandStatus')), ('status', ('\x00
', '00')), ('op_code', ('1\xfe', 'GAP_GetParam')), ('param_value', ('P\x00', '00
50'))]))
>>>
...- Parsing and Building of TI vendor-specific HCI packets
- Monitoring of serial BLE devices using the HostTestRelease application.
The library should support any TI single-mode BLE device that uses the HostTestRelease firmware. The below devices are those that have been tested
- TI CC2540DK-MINI Development Kit USB Dongle
To download pyblehci:
$ git clone https://stephenfinucane@code.google.com/p/pyblehci/To install:
$ python setup.py install- While most of the packets structures have been implemented in both the BLEParser and BLEBuilder modules, they are not complete. Additional packets can be found in the 'TI Vendor Specific HCI Guide' pdf document that is included in the TI BLE stack download