bmp180 is a micropython module for the Bosch BMP180 sensor. It measures temperature as well as pressure, with a high enough resolution to calculate altitude.

This code is based on pyboard code by Sebastian Plamauer, @turbinenreiter

Breakoutboard: http://www.ebay.at/itm/322193678288?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT

data-sheet: http://ae-bst.resource.bosch.com/media/products/dokumente/bmp180/BST-BMP180-DS000-09.pdf

If you have any questions, open an issue.

(just an example, I2C is implemented in software an can be run on any GPIO pin)

Example:

from bmp180 import BMP180
from machine import Pin
bmp180 = BMP180(scl=Pin(14),sda=Pin(12),freq=100000)
bmp180.oversample_sett = 2
bmp180.baseline = 101325
temp = bmp180.temperature
p = bmp180.pressure
altitude = bmp180.altitude
print(temp, p, altitude)

Important Notice:
Make sure to either use this in fast loops or call gauge() in fast loops to make sure to always get current values. If you call pressure() once and then again 10 seconds later, it will report a 10 seconds old value. Look at the gauge() function in the source to understand this. Alternatively use the blocking_read() method.

BMP180
Module for the BMP180 pressure sensor.

compvaldump() Returns a list of all compensation values.

gauge()
Generator refreshing the measurements. Does not need to be called manually.

temperature
Nonblocking read of temperature in degree C.

pressure
Nonblocking read of pressure in Pascal (divide result by 100 for millibar/hP).

blocking_read()
Trigger a read and wait until data is available.

altitude
Altitude in m.

chip_id
ID of chip is hardcoded on the sensor.

oversample_sett
Sets the accuracy. Default: 0

• 0 lowest accuracy, fastest
• 1
• 2
• 3 highest accuracy, slowest

baseline
Pressure at Main Sea Level. The default is 101325 Pa, but you can use your local QNH in Pa.
To get different altitudes, use this as baselines: