The IP address and Mac address of devices in topo:

Server:192.168.33.101 00:25:90:fc:cd:dc

Pica8: 192.168.33.104 48:6e:73:02:05:ad

Host1: 192.168.33.110 b8:27:eb:ed:94:03

Host2: 192.168.33.111 b8:27:eb:f0:4b:00

https://wiki.onosproject.org/display/ONOS/Building+ONOS

https://wiki.onosproject.org/display/ONOS/ONOS+from+Scratch

https://wiki.onosproject.org/display/ONOS/Developer+Quick+Start

$ screen /dev/ttyS0 115200

$ sudo picos_boot

Select the mode of pica8 as Open vSwitch mode

$ sudo service picos start

$ sudo reboot

sudo apt-get install mininet

$ ok clean

A bridge means a virtual switch, br* is the bridge name you set:

$ ovs-vsctl add-br br*

ge-1/1/* is the port number on Pica8:

$ ovs-vsctl add-port br* ge-1/1/* -- set Interface ge-1/1/* type=pica8

In switch mode you may not be able to connect with each other even if both devices connect to the same bridge,if you want to connect with each other without Pica8 connect to a controller, you can add a local flow rule and it will work.

Remember, te-1/1/1 represents 10G ports, while ge-1/1/1 represents 1G ports.

Add flow rule:

In this case we add a pair of bidirectional rules to allow connections between port1 and port2:

$ ovs-ofctl add-flow br* in_port=1,actions=output:2

$ ovs-ofctl add-flow br* in_port=2,actions=output:1

Delete flow

& ovs-ofctl del-flows br*

Modify behaviors of port in switch

$ ovs-ofctl mod-port up

$ ovs-ofctl mod-port down

$ ovs-ofctl dump-ports br0

$ ovs-ofctl dump-flows br0

The connection from bridge to SDN controller will start automatically after this command:

$ ovs-vsctl set-controller br* tcp:IP_address:6633

Delete Controller

$ ovs-vsctl del-controller br*

$ ovs-vsctl set Bridge br* protocols=OpenFlow14

$ netstat -an | grep 6633

Connection is successful if the connection of port 6633 shows established. Otherwise the connection is failed.

In order to connect Mininet with Pica8, we need to assign a physical ethernet port to Mininet switch. The example Mininet topo file are shown in testbed.py.

For more mininet example, you can visit https://github.com/mininet/mininet/tree/master/examples. In hwintf.py, it shows how to add an interface (for example a real hardware interface) to a network after the network is created.

Check the firewall rule with root permission

$ sudo UFW status

$ sudo UFW allow

$ sudo UFW deny

Make sure you are running Mininet version 2.2.1 or later:

$ mn --version

If not, try installing from the git repository https://github.com/mininet/mininet.git.

And make sure that Mininet works:

$ sudo mn --test pingall

Shutdown eth0 before connect to internet

$ sudo ifdown eth0

After connect to internet, enable eth0

$ sudo ifup eth0