# Client (sending)
##
client = udp_client.UDPClient(args.ip, args.port)
a = 0
state = 0
####
# LOOP
##
#send()
try:
print ("Press CTRL+C to exit")
while True:
time.sleep(.1)
if(a != gpio.input(enc0A)):
if(a == gpio.input(enc0B)):
state = state + 1
else:
state = state - 1
a = gpio.input(enc0A)
print (state)
osc_send(state,enc0)
__credits__ = ["Stefan Mavrodiev"]
__license__ = "GPL"
__version__ = "2.0"
__maintainer__ = __author__
__email__ = "*****@*****.**"
led = connector.gpio0p0 # This is the same as port.PH2
button = connector.gpio3p40
"""Init gpio module"""
gpio.init()
"""Set directions"""
gpio.setcfg(led, gpio.OUTPUT)
gpio.setcfg(button, gpio.INPUT)
"""Enable pullup resistor"""
gpio.pullup(button, gpio.PULLUP)
#gpio.pullup(button, gpio.PULLDOWN) # Optionally you can use pull-down resistor
try:
print ("Press CTRL+C to exit")
while True:
state = gpio.input(button) # Read button state
"""Since we use pull-up the logic will be inverted"""
gpio.output(led, not state)
except KeyboardInterrupt:
print ("Goodbye.")
####
# Client (sending)
##
client = udp_client.UDPClient(args.ip, args.port)
a = 0
state = 0
####
# LOOP
##
#send()
try:
print("Press CTRL+C to exit")
while True:
time.sleep(.1)
if (a != gpio.input(enc0A)):
if (a == gpio.input(enc0B)):
state = state + 1
else:
state = state - 1
a = gpio.input(enc0A)
print(state)
osc_send(state, enc0)
except KeyboardInterrupt:
print("Goodbye.")