def main():
log = LogData(logging.INFO)
rr = RepRap()
rr.connect(port="/dev/ttyACM0", baudrate=115200)
scan = Scanner(log, rr, "em3d.out", (13, 10, 5), (0.5, 0.1))
scan.getCoordTuple()
#x = scan.createStepPointsX()
#y = scan.createStepPointsY()
#z = scan.createStepPointsZ()
#print x
#print y
#print z
#scan.oneRow()
#scan.moveOneStepXforward("1.5", '-')
list = [0.0, 1.0, 2.0, 30.0, 4.0, 5.0, 100.0, 7.0, 8.0, 9.0, 10.0, 16.0]
scan.mX(list, "na", "of")
rr.disconnect()
pass
def ShowAndRender(self):
""" Calls Show() and Render() methods in ParaView
"""
Show()
Render()
dim = GetDimensionsList()
wave1 = MyWavelet(dim.GetDimensions())
wave1.SetPointDataToCellData("Amplitude")
#wave2 = MyWavelet(dim.GetDimensions())
#wave2.SetPointDataToCellData("Phase")
pna = NetworkAnalyzer()
rf = RfAtmega128()
transmistter = RfAtmega128()
reprap = RepRap()
# check if RepRap printer exists
if reprap.connect("/dev/ttyACM0", 115200) is True:
print "Wavelet dimensions: ", dim.GetDimensions()
reprap.setMeasureDimensions(dim.GetDimensions())
print "Number of points to measure: ", reprap.getNumberOfMeasurePoints()
else:
print "No RepRap printer found."
# select measure device
# 1 = PNA Agilent N5230C
# 2 = rfAtmega128 board (Arduino with Zigbee)
# programmed as Spectrum Analyzer
measurementDevice = "2"
