def try_connect(ipadx):
try:
connect_ssh = ConnectHandler(device_type='cisco_ios_telnet',
username=ipadx[1],
password=ipadx[2],
secret=ipadx[3],
ip=ipadx[0])
connect_ssh.enable()
find_hostname = connect_ssh.find_prompt()
connect_ssh.send_command("terminal len 0")
connect_ssh.open_session_log('results/' + find_hostname + '.txt', 'w')
connect_ssh.send_command('sh run') # you can edit this command
connect_ssh.close_session_log()
except:
die.append(ipadx)
diel.write(ipadx + '\n')
continue
best_match = guesser.autodetect()
print("This device is detected to be model type: " + best_match)
if best_match not in ['cisco_ios', 'cisco_nxos', 'cisco_xr']:
print("ERROR: " + best_match + " is not currently supported in this revision")
continue
else:
remote_device['device_type'] = best_match
ssh_connection = ConnectHandler(**remote_device)
ssh_connection.open_session_log("session-log-"+device+".log", mode=u'write')
# enter enable mode
ssh_connection.enable()
# prepend the command prompt to the result (used to identify the local host)
result = ssh_connection.find_prompt() + "\n"
print ("Device name is: "+result)
# execute the show cdp neighbor detail command
# we increase the delay_factor for this command, because it take some time if many devices are seen by CDP
if best_match == 'cisco_ios':
cmds = commands.commands_ios
elif best_match == 'cisco_nxos':
cmds = commands.commands_nxos
from netmiko import ConnectHandler
from getpass import getpass
my_switch = {
'host': '192.168.122.71',
'username': '******',
'password': '******',
'device_type': 'cisco_ios',
}
net_conn = ConnectHandler(**my_switch)
net_conn.open_session_log('{}-2018'.format(my_switch['host']))
filename = 'show_running.0t3B'
cmd = 'delete flash0:{}'.format(filename)
#output = net_conn.send_command(cmd)
output = net_conn.send_command_timing(cmd)
if 'Delete filename' in output:
output += net_conn.send_command_timing("\n")
output += net_conn.send_command_timing("\n")
print(output)
net_conn.disconnect
