c = combiner_runtime(cfg=None)
c.progress = gui.updProgressBar
c.printCAL()
opid = gui.EnterOperatorID()
while 1:
pw = PromptWindow( gui,"**** Ready UUT for test ****",
"1) Place board in test fixture\n" + \
"2) Connect the cables\n\n",
yestxt = "Start Test", notxt = "Exit Program")
response = pw.answer.get()
print response
if response =='0':
break
gui.elapsedTime(0)
part_number, hwrev, ccode, model = gui.scan_part_number()
gui.set_ssid(model)
pw = EntryWindow( gui, "Scan Serial Number ", 'Enter UUT serial number', '')
serialnumber = pw.answer.get()
db = Db(cfg.get('DBFILE'), cfg.get('DBTBL'))
c.dbWrite=db.Entry
db.Entry(model,"model")
db.Entry(serialnumber,'serial')
db.Entry(opid,'operator_id')
db.Entry(rev.getSwVer(),'test_swver')
if model == '2x2':
l = testLimits(limitsDict=limits2x2)
testSeq = c.Seq2X2
c = combiner_runtime(cfg=None)
c.progress = gui.updProgressBar
c.printCAL()
opid = gui.EnterOperatorID()
while 1:
pw = PromptWindow( gui,"**** Ready UUT for test ****",
"1) Place board in test fixture\n" + \
"2) Connect the cables\n\n",
yestxt = "Start Test", notxt = "Exit Program")
response = pw.answer.get()
print response
if response == '0':
break
gui.elapsedTime(0)
part_number, hwrev, ccode, model = gui.scan_part_number()
gui.set_ssid(model)
pw = EntryWindow(gui, "Scan Serial Number ", 'Enter UUT serial number',
'')
serialnumber = pw.answer.get()
db = Db(cfg.get('DBFILE'), cfg.get('DBTBL'))
c.dbWrite = db.Entry
db.Entry(model, "model")
db.Entry(serialnumber, 'serial')
db.Entry(opid, 'operator_id')
db.Entry(rev.getSwVer(), 'test_swver')
if model == '2x2':
l = testLimits(limitsDict=limits2x2)
