from litex.soc.tools.remote import RemoteClient
from litescope.software.driver.analyzer import LiteScopeAnalyzerDriver
wb = RemoteClient()
wb.open()
# # #
analyzer = LiteScopeAnalyzerDriver(wb.regs, "analyzer", debug=True)
analyzer.configure_trigger(cond={"s7pciephy_sink_valid": 1})
#analyzer.configure_trigger(cond={})
analyzer.configure_subsampler(1)
analyzer.run(offset=16, length=64)
analyzer.wait_done()
analyzer.upload()
analyzer.save("dump.vcd")
# # #
wb.close()
# 7-series SERDES in DDR mode needs 3 pulses for 1 bitslip
for j in range(3):
regs.ddrphy_rdly_dq_bitslip.write(1)
for i in range(delay):
regs.ddrphy_rdly_dq_inc.write(1)
#
test_size = 1024*1024
run_analyzer = True
#
analyzer.configure_trigger(cond={"generator_start_re": 1})
analyzer.configure_trigger(cond={"checker_start_re": 1})
analyzer.configure_subsampler(1)
analyzer.run(offset=16, length=512)
regs.generator_reset.write(1)
regs.generator_reset.write(0)
regs.generator_base.write(0)
regs.generator_length.write((test_size*8)//128)
regs.generator_start.write(1)
while(not regs.generator_done.read()):
pass
regs.checker_reset.write(1)
regs.checker_reset.write(0)
regs.checker_base.write(0)
regs.checker_length.write((test_size*8)//128)
from litex.tools.litex_client import RemoteClient
from litescope.software.driver.analyzer import LiteScopeAnalyzerDriver
wb = RemoteClient()
wb.open()
analyzer = LiteScopeAnalyzerDriver(wb.regs, "analyzer", debug=True)
analyzer.configure_subsampler(
1) ## increase this to "skip" cycles, e.g. subsample
analyzer.configure_group(0)
# trigger conditions will depend upon each other in sequence
#analyzer.add_rising_edge_trigger("adc_i_fclk1")
analyzer.add_rising_edge_trigger("adc_i_we0")
analyzer.run(offset=16, length=512) ### CHANGE THIS TO MATCH DEPTH
analyzer.wait_done()
analyzer.upload()
analyzer.save("dump.vcd")
wb.close()
def main():
args, wb = connect("LiteX Etherbone Memtest BIST", target='memtest')
print_memmap(wb)
print()
main_ram = wb.mems.main_ram
print("DDR at 0x{:x} -- {} Megabytes".format(
main_ram.base, int(main_ram.size / (1024 * 1024))))
print()
# init
print("Reset")
wb.regs.generator_reset.write(1)
wb.regs.checker_reset.write(1)
wb.regs.generator_reset.write(0)
wb.regs.checker_reset.write(0)
assert not wb.regs.checker_scope_error.read()
print()
analyzer = LiteScopeAnalyzerDriver(wb.regs,
"analyzer",
config_csv='{}/analyzer.csv'.format(
make_testdir(args)),
debug=True)
print("Init analyzer")
#analyzer.configure_trigger(cond={'checker_core_data_error': 1})
analyzer.configure_trigger(cond={'data_error': 1})
analyzer.configure_trigger(cond={})
analyzer.configure_subsampler(1)
analyzer.run(offset=16, length=1024)
assert not analyzer.done()
print()
base = int(512e3)
#length = int((main_ram.size-base)*8/16) # 64e6 == 64 megabytes
#length = int(2e6)
length = int(1)
# write
print("Write")
write_and_check(wb.regs.generator_base, base)
write_and_check(wb.regs.generator_length, length)
assert not wb.regs.generator_done.read()
wb.regs.generator_start.write(1)
print("Waiting", end=' ')
while wb.regs.generator_done.read() == 0:
print(".", end='', flush=True)
time.sleep(0.1)
assert wb.regs.generator_done.read() == 1
print()
# read
assert wb.regs.checker_err_count.read() == 0
print("Read")
write_and_check(wb.regs.checker_base, base)
write_and_check(wb.regs.checker_length, length)
assert not wb.regs.checker_done.read()
assert not analyzer.done()
wb.regs.checker_start.write(1)
print("Waiting")
while wb.regs.checker_done.read() == 0:
print(" Errors:", wb.regs.checker_err_count.read())
time.sleep(0.1)
assert wb.regs.checker_done.read() == 1
print("Final errors:", wb.regs.checker_err_count.read())
errors = wb.regs.checker_err_count.read()
if errors != 0:
# Check litescope
assert analyzer.done()
analyzer.upload()
analyzer.save('sim.vcd')
data = {v.name: v for v in analyzer.dump().variables}
okay = set()
errors = {}
for i in range(0, len(data['clk'].values)):
address = hex(data['data_address'].values[i])
if data['data_error'].values[i] != 1:
okay.add(address)
continue
expected = data['data_expected'].values[i]
actual = data['data_actual'].values[i]
r = MemError(address, hex(expected), hex(actual))
if address in errors:
assert errors[address] == r
else:
errors[address] = r
import pprint
print(len(errors))
pprint.pprint(errors)
from IPython import embed
embed()
#print("Error @ {} - {:x} != {:x}".format(addr, expect, actual))
print("Done!")
wb.close()
