run with: python3 tutorial2.py
================================================
This example uses the write_pin and writePort methods to switch pin 1 on
and off on the IO Pi.
"""
from ABE_helpers import ABEHelpers
from ABE_IoPi import IoPi
import time
i2c_helper = ABEHelpers()
i2c_bus = i2c_helper.get_smbus()
bus = IoPi(i2c_bus, 0x20)
bus.set_pin_direction(1, 1) # set pin 1 as an input
bus.set_pin_direction(8, 0) # set pin 8 as an output
bus.write_pin(8, 0) # turn off pin 8
bus.set_pin_pullup(1, 1) # enable the internal pull-up resistor on pin 1
bus.invert_pin(1, 1) # invert pin 1 so a button press will register as 1
while True:
if bus.read_pin(1) == 1: # check to see if the button is pressed
print('button pressed') # print a message to the screen
bus.write_pin(8, 1) # turn on the led on pin 8
time.sleep(2) # wait 2 seconds
CounterPinValue = {}
PinNextSend = {}
TempoPinHIGH = {}
TempoPinLOW = {}
Status_pins = {}
Status_INPUTS = {}
swtch = {}
exit = 0
SetAllLOW = 0
SetAllHIGH = 0
SetAllSWITCH = 0
SetAllPulseLOW = 0
SetAllPulseHIGH = 0
pinStr = ''
for i in range(0, 16):
bus.set_pin_direction(i + 1, 1)
input = bus.read_pin(i + 1)
Status_INPUTS[i] = input
pinStr += '&IN_' + str(i) + '=' + str(input)
CounterPinValue[i] = 0
PinNextSend[i] = 0
TempoPinHIGH[i] = 0
TempoPinLOW[i] = 0
swtch[i] = 0
Status_pins[i] = '.'
# Envoi de l'etats des inputs au boot
if pinStr != '':
SimpleSend(pinStr)
threadLock = threading.Lock()
run with: sudo python tutorial1.py
================================================
This example uses the write_pin and writePort methods to switch pin 1 on
and off on the IO Pi.
"""
from ABE_helpers import ABEHelpers
from ABE_IoPi import IoPi
import time
i2c_helper = ABEHelpers()
i2c_bus = i2c_helper.get_smbus()
bus = IoPi(i2c_bus, 0x20)
bus.set_pin_direction(1, 1) # set pin 1 as an input
bus.set_pin_direction(8, 0) # set pin 8 as an output
bus.write_pin(8, 0) # turn off pin 8
bus.set_pin_pullup(1, 1) # enable the internal pull-up resistor on pin 1
bus.invert_pin(1, 1) # invert pin 1 so a button press will register as 1
while True:
if bus.read_pin(1) == 1: # check to see if the button is pressed
print 'button pressed' # print a message to the screen
bus.write_pin(8, 1) # turn on the led on pin 8
