class PiButton():
def __init__(self):
self.HOST = '192.168.10.10'
self.PORT = 50007
self.socketClient = SocketClient(self.HOST, self.PORT)
def start(self):
# Use BCM GPIO references
# instead of physical pin numbers
GPIO.setmode(GPIO.BCM)
# Define GPIO to use on Pi
GPIO_BUTTON = 8
#print "PIR Module Holding Time Test (CTRL-C to exit)"
# Set pin as input
GPIO.setup(GPIO_BUTTON, GPIO.IN) # Echo
# Input states
input = 0
prevInput = 1
try:
# Loop until users quits with CTRL-C
while True:
input = GPIO.input(GPIO_BUTTON)
if ((not prevInput) and input):
#print "Button pressed"
time.sleep(0.3)
self.socketClient.connectUDP()
self.socketClient.send("Button pressed")
self.socketClient.close()
prevInput = input
time.sleep(0.01)
except KeyboardInterrupt:
print " Quit"
# Reset GPIO settings
self.clean()
def clean(self):
GPIO.cleanup()
class Pir(threading.Thread):
def __init__(self, GPIO):
self.HOST = '192.168.10.10'
self.PORT = 50007
self.socketClient = SocketClient(self.HOST, self.PORT)
self.GPIO_PIR = GPIO
# Threading init
threading.Thread.__init__(self)
self.setName("PIR" + str(self.GPIO_PIR))
self.daemon = True
def run(self):
self.detect()
def detect(self):
# Use BCM GPIO references
# instead of physical pin numbers
GPIO.setmode(GPIO.BCM)
#print "PIR Module Holding Time Test (CTRL-C to exit)"
# Set pin as input
GPIO.setup(self.GPIO_PIR, GPIO.IN) # Echo
Current_State = 0
Previous_State = 0
try:
#print "Waiting for PIR to settle ..."
# Loop until PIR output is 0
while GPIO.input(self.GPIO_PIR) == 1:
Current_State = 0
#print " Ready"
data = 0
# Loop until users quits with CTRL-C
while True:
time.sleep(0.01)
# Read PIR state
Current_State = GPIO.input(self.GPIO_PIR)
if Current_State == 1 and Previous_State == 0:
# PIR is triggered
print " Motion detected!"
self.socketClient.connectUDP()
self.socketClient.send(self.getName())
#print "motion sent"
#data = self.socketClient.recieve()
#time.sleep(1)
#print "Recieved ", data
self.socketClient.close()
# Record previous state
time.sleep(1)
Previous_State = 1
elif Current_State == 0 and Previous_State == 1:
time.sleep(1)
Previous_State = 0
except KeyboardInterrupt:
print " Quit"
# Reset GPIO settings
self.clean()
def clean(self):
GPIO.cleanup()
