def __init__(self, loginVo, sensorName):
logger.info('ProcessLedGreen init')
self.loginVo = loginVo
self.sensorName = sensorName
DAQC.clrLED(0, 0)
DAQC.clrLED(0, 1)
DAQC.enableSWint(0)
DAQC.intEnable(0)
self.ledColor = 'green'
self.btnPressed = '0'
def run(self, *args):
logger.info("ButtonPushedThread run start")
DAQC.enableSWint(self.daqcBoard)
DAQC.intEnable(self.daqcBoard)
while True:
if self.isShutdown:
break
if DAQC.getINTflags(self.daqcBoard) == 256:
self.pillDispenser.setDispenseState('CONFIRMING')
break
time.sleep(.25)
def leds():
DAQC.enableSWint(0)
DAQC.intEnable(0)
while True:
DAQC.setLED(0, 0)
if DAQC.getINTflags(0) == 256:
break
time.sleep(.25)
if DAQC.getINTflags(0) == 256:
break
DAQC.clrLED(0, 0)
if DAQC.getINTflags(0) == 256:
break
time.sleep(.25)
if DAQC.getINTflags(0) == 256:
break
for i in range(0, 100):
DAQC.clrLED(0, 0)
DAQC.clrLED(0, 1)
pressure = sensor.read_pressure() / 100. # convert to hectopascals
humidity = sensor.read_humidity()
t = sensor.t_fine
# measure from the (analog) photo-sensor
light = DAQC.getADC(0, 0)
global data
data.append([t, temp, pressure, humidity, light])
# turn off LEDs
DAQC.setDOUTall(0, 0)
# set up GPIO interface for pushbotton on PiDAQC
DAQC.enableSWint(0) # enable pushbutton interrupt
DAQC.intEnable(0) # enable global interrupts
DAQC.getINTflags(0) # clear any flags
# GPIO event detection must be set up AFTER clearing DAQC interrupt flag
GPIO.setmode(GPIO.BCM)
GPIO.setup(22, GPIO.IN, pull_up_down=GPIO.PUD_UP)
GPIO.add_event_detect(22, GPIO.FALLING, callback=sample)
DAQC.getINTflags(0)
# set up BME280
sensor = BME280(mode=BME280_OSAMPLE_8)
try:
while (1):
# wait for button