def put(self, request, device_id):
io_command_pairs = []
io_set_setting_pairs = []
io_serial_data_values = []
# Sanitize and sort inputs
for name, value in request.DATA.iteritems():
# May get '/' seperators, mixed case, etc. Strip out non-alphanum
# chars, make uppercase.
name = str(name).translate(None, self.delchars).upper()
# Check for DIO and extract the bit position of this pin
match = re.match(r"(DIO)(?P<bit>[0-9]+)", name)
if match:
bit = match.group('bit')
# Convert boolean-ish values to True/False
if type(value) == str or type(value) == unicode:
try:
value = bool(strtobool(value))
except ValueError:
# Try to catch "high"/"low"
if value.lower() == "high":
value = True
elif value.lower() == "low":
value = False
else:
return Response(status=status.HTTP_400_BAD_REQUEST)
io_command_pairs.append((int(bit), value))
# Else see if it looks like a traditional AT command
elif len(name) == 2: # M0, etc AT command, used for PWM setting
# Some commands require hex strings, others integers, others
# arbitrary text...ug
try:
# Hex
if name in ['M0', 'M1', 'IC', 'PR', 'PD', 'DS']:
val_str = hex(int(value))
elif (name in ['LT', 'RP', 'IR', 'IF'] or
name.startswith('T') or name.startswith('Q')):
val_str = str(int(value))
else:
# Use as is
val_str = str(value)
except ValueError:
return Response(status=status.HTTP_400_BAD_REQUEST)
io_set_setting_pairs.append((name, val_str))
# Handle serial output. Currently don't support sending to
# different targets, so combine all
# serial messages into a single payload
elif name.startswith("SERIAL"):
io_serial_data_values.append(value)
else:
# Unknown command provided
return Response(status=status.HTTP_400_BAD_REQUEST)
username, password, cloud_fqdn = get_credentials(request)
if not username or not password or not cloud_fqdn:
return Response(status=status.HTTP_400_BAD_REQUEST)
conn = DeviceCloudConnector(username, password, cloud_fqdn)
resp = {}
try:
# For IO command, need to generate two bitmasks - enable and level
if len(io_command_pairs):
enable_mask = 0
output_mask = 0
for bit, value in io_command_pairs:
enable_mask |= 1 << int(bit)
output_mask |= value << int(bit)
resp = conn.set_output(device_id,
hex(enable_mask), hex(output_mask))
if len(io_set_setting_pairs):
# Because these settings belong to a single known group, we can
# construct the request for the user
new_settings = {'InputOutput': {}}
for name, val in io_set_setting_pairs:
new_settings['InputOutput'][name] = val
resp = conn.set_device_settings(device_id, new_settings)
if len(io_serial_data_values):
data = "".join(io_serial_data_values)
data = base64.b64encode(data)
resp = conn.send_serial_data(device_id, data)
except HTTPError, e:
return Response(status=e.response.status_code,
data=e.response.text)
