def __init__(self, spi, rst, ce, dc, light, pwr=None):
self.width = 84
self.height = 48
self.power = self.POWER_DOWN
self.addressing = self.ADDRESSING_HORIZ
self.instr = self.INSTR_BASIC
self.display_mode = self.DISPLAY_BLANK
self.temp_coeff = self.TEMP_COEFF_0
self.bias = self.BIAS_1_11
self.voltage = 3060
# init the SPI bus and pins
spi.init(spi.MASTER,
baudrate=328125,
bits=8,
polarity=0,
phase=1,
firstbit=spi.MSB)
if "OUT_PP" in dir(rst):
# pyBoard style
rst.init(rst.OUT_PP, rst.PULL_NONE) # Reset line
ce.init(ce.OUT_PP, ce.PULL_NONE) # Chip Enable
dc.init(dc.OUT_PP, dc.PULL_NONE) # Data(1) / Command(0) mode
light.init(light.OUT_PP, light.PULL_NONE)
if pwr:
pwr.init(pwr.OUT_PP, pwr.PULL_NONE)
else:
# WiPy style
rst.init(rst.OUT, None)
ce.init(ce.OUT, None)
dc.init(dc.OUT, None)
light.init(light.OUT, None)
if pwr:
pwr.init(pwr.OUT, None)
self.spi = spi
self.rst = rst
self.ce = ce
self.dc = dc
self.light = light
self.pwr = pwr
self.light_off()
self.power_on()
self.ce.value(1) # set chip to disable (don't listen to input)
self.reset()
self.set_contrast(0xbf)
self.command([0x21, 0])
self.command([0xb0, 0])
self.command([0x20, 0])
self.clear()
self.lcd_font = font.FONT6_8()
self.lcd_pictuer = pictuer.pictuer()
self.hc = [[0 for i in range(84)] for j in range(6)]
self.tab1 = [0x01, 0x02, 0x04, 0x08, 0x10, 0x20, 0x40, 0x80]
def __init__(self, spi, cs, dc, rst=None):
self.width = 84
self.height = 48
self.spi = spi
self.cs = cs # chip enable, active LOW
self.dc = dc # data HIGH, command LOW
self.rst = rst # reset, active LOW
self.lcd_font = font.FONT6_8()
self.chinese = chinese.CN_UTF8()
self.chinese1 = chinese1.CN_UTF8()
self.cs.init(self.cs.OUT, value=1)
self.dc.init(self.dc.OUT, value=0)
if self.rst:
self.rst.init(self.rst.OUT, value=1)
self.reset()
self.init()