class Fields:
pinSel = X4(1) # Mask of Pins Set as Peripheral/PIO
pinBank = X4(2) # Mask of Pins Set as Bank A/B
pinDir = X4(3) # Mask of Pins Set as Input/Output
pinVal = X4(4) # Mask of Pins Value Low/High
noisePerMS = U2(5) # Noise Level as measured by the GPS Core
agcCnt = U2(
6) # AGC Monitor (counts SIGHI xor SIGLO, range 0 to 8191)
aStatus = U1(
7
) # Status of the Antenna Supervisor State Machine (0=INIT, 1=DONTKNOW, 2=OK, 3=SHORT, 4=OPEN)
aPower = U1(
8) # Current PowerStatus of Antenna (0=OFF, 1=ON, 2=DONTKNOW)
flags = X1(9) # Flags (see graphic below)
reserved1 = U1(10)
usedMask = X4(
11) # Mask of Pins that are used by the Virtual Pin Manager
VP = CH(
12,
17) # Array of Pin Mappings for each of the 17 Physical Pins
jamInd = U1(
13
) # CW Jamming indicator, scaled (0 = no CW jamming, 255 = strong CW jamming)
reserved2 = U2(14)
pinIrq = X4(15) # Mask of Pins Value using the PIO Irq
pullH = X4(
16) # Mask of Pins Value using the PIO Pull High Resistor
pullL = X4(
17) # Mask of Pins Value using the PIO Pull Low Resistor
class Fields:
measRate = U2(1)
navRate = U2(2)
timeRef = U2(3,
allowed={
0: "UTC time",
1: "GPS time",
2: "GLONASS time",
3: "BeiDou time",
4: "Galileo time"
})
class Fields:
timeTag = U4(1)
flags = X2(2)
id = U2(3)
class Repeated:
data = X4(1)
class Fields:
portID = U1(1)
reserved1 = U1(2)
txReady = X2(3)
mode = X4(4)
reserved2 = U4(5)
inProtoMask = X2(6)
outProtoMask = X2(7)
flags = X2(8)
reserved3 = U2(9)
class Fields:
dur = U4(1)
meanX = I4(2)
meanY = I4(3)
meanZ = I4(4)
meanV = U4(5)
obs = U4(6)
valid = U1(7)
active = U1(8)
reserved = U2(9)
class Fields:
iTOW = U4(1)
gDOP = U2(2)
pDOP = U2(3)
tDOP = U2(4)
vDOP = U2(5)
hDOP = U2(6)
nDOP = U2(7)
eDOP = U2(8)
class Fields:
version = U1(1) # Message version (0x02 for this version)
reserved1 = U1(2) # Reserved
maxStartupStartupDur = U1(
3
) # Maximum time to spend in Acquisition state. If 0: bound disabled (see maxStartupStateDur). (not supported in protocol versions less than 17), (not supported in protocol versions 23 to 23.01)
reserved2 = U1(4) # Reserved
flags = X4(5) # PSM configuration flags (see graphic below)
updatePeriod = U4(
6
) # ms Position update period. If set to 0, the receiver will never retry a fix and it will wait for external events
searchPeriod = U4(
7
) # ms Acquisition retry period if previously failed. If set to 0, the receiver will never retry a startup (not supported in protocol versions 23 to 23.01)
gridOffset = U4(
8
) # ms Grid offset relative to GPS start of week (not supported in protocol versions 23 to 23.01)
onTime = U2(
9
) # s Time to stay in Tracking state (not supported in protocol versions 23 to 23.01)
minAcqTime = U2(10) # s minimal search time
reserved3 = U(11, 20) # Reserved
extintInactivityMs = U4(
12) # ms inactivity time out on EXTINT pint if enabled
class Fields:
tpIdx = U1(
1) # Time pulse selection (0 = TIMEPULSE, 1 = TIMEPULSE2)
version = U1(2) # Message version (0x00 for this version)
reserved2 = U2(3)
antCableDelay = I2(4) # Antenna cable delay
rfGroupDelay = I2(5) # RF group delay
freqPeriod = U4(
6
) # Frequency or period time, depending on setting of bit 'isFreq'
freqPeriodLock = U4(
7
) # Frequency or period time when locked to GPS time, only used if 'lockedOtherSet' is set
pulseLenRatio = U4(
8) # Pulse length or duty cycle, depending on 'isLength'
pulseLenRatioLock = U4(
9
) # Pulse length or duty cycle when locked to GPS time, only used if 'lockedOtherSet' is set
userConfigDelay = I4(10) # User configurable time pulse delay
flags = X4(11) # Configuration flags
class Fields:
iTOW = U4(1)
numCh = U1(2)
globalFlags = X1(3,
allowed={
0: 'Antaris',
1: 'u-Blox 5',
2: 'u-Blox 6',
3: 'u-Blox 7',
4: 'u-Blox 8',
})
reserved1 = U2(4)
class Repeated:
chn = U1(1)
svid = U1(2)
flags = X1(3)
quality = X1(4)
cno = U1(5)
elev = I1(6)
axim = I2(7)
prRes = I4(8)
class Fields:
version = U1(1)
powerSetupValue = U1(2)
period = U2(3)
onTime = U2(4)
reserved = U2(5)
class Repeated:
ext = U2(1)