from pybpodapi.com.arcom import ArCOM, ArduinoTypes
import time
import threading
bpod = Bpod()
trials = 10
#==============================================================================
# rotary encoder config
#==============================================================================
rotary_encoder = [x for x in bpod.modules if x.name == "RotaryEncoder1"][0]
reset_re = 1
bpod.load_serial_message(rotary_encoder, 1, [ord('Z'), ord('E')])
bpod.load_serial_message(rotary_encoder, 2, [ord("#"), 2])
#====================================
# onfigure encoder
#====================================
rotary_encoder = RotaryEncoderModule('COM6')
ALL_THRESHOLDS = [-10, 10]
ENABLE_THRESHOLDS = [True, True, False, False, False, False, False, False]
rotary_encoder.set_zero_position() # Not necessarily needed
rotary_encoder.set_thresholds(ALL_THRESHOLDS)
rotary_encoder.enable_thresholds(ENABLE_THRESHOLDS)
rotary_encoder.enable_evt_transmission()
rotary_encoder.close()
waveplayer.set_loop_mode(
[False, False, False, False, False, False, False, False])
#waveplayer.set_loop_mode([False, False, False, False])
waveplayer.debug()
print(waveplayer.load_waveform(1, wave))
waveplayer.disconnect()
# create bpod object all necessary settings are imported from GUI
bpod = Bpod('COM5')
bpod.modules[0].name
bpod.modules[1].name
wave_player = [x for x in bpod.modules if x.name == "WavePlayer1"][0]
bpod.load_serial_message(wave_player, 1, [ord('P'), 3, 0]) #15=1111
#wave_player.load_message([ord('P'), 15, 1],1)
"""
for _ in range(10):
print(f"loop:{_}")
waveplayer.play(1,1)
waveplayer.play(2,1)
waveplayer.play(3,1)
waveplayer.play(4,1)
time.sleep(5)
waveplayer.stop()
waveplayer.disconnect()"""
#from pybpodapi.com.arcom import ArCOM, ArduinoTypes