def leave_dfu(serial):
"""Leave ST DFU bootloader.
Switches to Solo bootloader or firmware, latter if firmware is valid.
This changes the boot options of the key, which only reliably
take effect after a powercycle.
"""
dfu = solo.dfu.find(serial) # select option bytes
dfu.init()
dfu.prepare_options_bytes_detach()
try:
dfu.detach()
except usb.core.USBError:
pass
hot_patch_windows_libusb()
print("Please powercycle the device (pull out, plug in again)")
def dfu(serial, connect_attempts, detach, dry_run, firmware):
"""Program via STMicroelectronics DFU interface.
Enter dfu mode using `solo program aux enter-dfu` first.
"""
import time
import usb.core
from intelhex import IntelHex
dfu = solo.dfu.find(serial, attempts=connect_attempts)
if dfu is None:
print("No STU DFU device found.")
if serial is not None:
print("Serial number used: ", serial)
sys.exit(1)
dfu.init()
if not dry_run:
# The actual programming
# TODO: move to `operations.py` or elsewhere
ih = IntelHex()
ih.fromfile(firmware, format="hex")
chunk = 2048
# Why is this unused
# seg = ih.segments()[0]
size = sum([max(x[1] - x[0], chunk) for x in ih.segments()])
total = 0
t1 = time.time() * 1000
print("erasing...")
try:
dfu.mass_erase()
except usb.core.USBError:
# garbage write, sometimes needed before mass_erase
dfu.write_page(0x08000000 + 2048 * 10, "ZZFF" * (2048 // 4))
dfu.mass_erase()
page = 0
for start, end in ih.segments():
for i in range(start, end, chunk):
page += 1
data = ih.tobinarray(start=i, size=chunk)
dfu.write_page(i, data)
total += chunk
# here and below, progress would overshoot 100% otherwise
progress = min(100, total / float(size) * 100)
sys.stdout.write(
"downloading %.2f%% %08x - %08x ... \r" %
(progress, i, i + page))
# time.sleep(0.100)
# print('done')
# print(dfu.read_mem(i,16))
t2 = time.time() * 1000
print()
print("time: %d ms" % (t2 - t1))
print("verifying...")
progress = 0
for start, end in ih.segments():
for i in range(start, end, chunk):
data1 = dfu.read_mem(i, 2048)
data2 = ih.tobinarray(start=i, size=chunk)
total += chunk
progress = min(100, total / float(size) * 100)
sys.stdout.write("reading %.2f%% %08x - %08x ... \r" %
(progress, i, i + page))
if (end - start) == chunk:
assert data1 == data2
print()
print("firmware readback verified.")
if detach:
dfu.prepare_options_bytes_detach()
dfu.detach()
print("Please powercycle the device (pull out, plug in again)")
hot_patch_windows_libusb()