Beispiel #1
0
def prepare_for_next_run(suite):
    devices = [device for device in all_devices]
    print "Start preparing for the next {0} run".format(suite.upper())
    if len(devices) > 0:
        for device in devices:
            serial = device["serial"]
            print "Prepare device {0} for next build.".format(device)
            print "Will try to use adb connection to shutdown/put the device into sleep mode"
            if local_utils.has_adb_serial(serial = serial):
                if shutdown_to_charge:
                    print "[ {0} ]: Shutdown device to charge".format(serial)
                    local_steps.command(command = "adb -s {0} shell reboot -p".format(serial))()
                    time.sleep(5)
                    print "[ {0} ]: Shutdown - Done!".format(serial)
                else:
                    print "[ {0} ]: Put device into sleep mode".format(serial)
                    adb_steps.put_device_into_sleep_mode(serial = serial)()
                    print "[ {0} ]: Sleep - Done!".format(serial)
            else:
                print "[ {0} ]: does not have adb connection!!!".format(serial)
                print "[ {0} ]: Try to use relay to shutdown the devices".format(serial)
                try:
                    my_relay = Relayed_device(relay_port = device["relay"]["tty"],
                                            power_port = device["relay"]["power_port"],
                                            v_up_port = device["relay"]["v_up_port"],
                                            v_down_port = device["relay"]["v_down_port"])
                    my_relay.power_on()
                    my_relay.power_off()
                    my_relay.close()
                except Exception, e:
                    print "{0} devivice has no relay - {1}!!!".format(serial, e.message)
Beispiel #2
0
    s = d["serial"]
    print "Prepare device " + str(s) + " for next build."
    print "Will try to use adb connection to shutdown/put to sleep the device"
    if local_utils.has_adb_serial(serial=s):
        adb_steps.enable_uiautomator_service(serial=s, timeout=120)()
        if shutdown_to_charge:
            print str(s) + ": Shutdown device to charge"
            local_steps.command(command="adb -s " + str(s) +
                                " shell reboot -p")()
            time.sleep(5)
            print str(s) + ": Shutdown - Done!"
        else:
            print str(s) + ": Put device to sleep"
            adb_steps.put_device_into_sleep_mode(serial=s)()
            print str(s) + ": Sleep - Done!"
    else:
        print str(s) + ": does not have adb connection!!!"
        print str(s) + ": Try to use relay to shutdown the devices"
        try:
            my_relay = Relayed_device(relay_port=d["relay"]["tty"],
                                      power_port=d["relay"]["power_port"],
                                      v_up_port=d["relay"]["v_up_port"],
                                      v_down_port=d["relay"]["v_down_port"])
            my_relay.power_on()
            my_relay.power_off()
            my_relay.close()
        except Exception, e:
            print "NO relay!!!"
            print e.message
########################################################################