def prepare_for_next_run(suite):
devices = [device for device in all_devices]
print "Start preparing for the next {0} run".format(suite.upper())
if len(devices) > 0:
for device in devices:
serial = device["serial"]
print "Prepare device {0} for next build.".format(device)
print "Will try to use adb connection to shutdown/put the device into sleep mode"
if local_utils.has_adb_serial(serial = serial):
if shutdown_to_charge:
print "[ {0} ]: Shutdown device to charge".format(serial)
local_steps.command(command = "adb -s {0} shell reboot -p".format(serial))()
time.sleep(5)
print "[ {0} ]: Shutdown - Done!".format(serial)
else:
print "[ {0} ]: Put device into sleep mode".format(serial)
adb_steps.put_device_into_sleep_mode(serial = serial)()
print "[ {0} ]: Sleep - Done!".format(serial)
else:
print "[ {0} ]: does not have adb connection!!!".format(serial)
print "[ {0} ]: Try to use relay to shutdown the devices".format(serial)
try:
my_relay = Relayed_device(relay_port = device["relay"]["tty"],
power_port = device["relay"]["power_port"],
v_up_port = device["relay"]["v_up_port"],
v_down_port = device["relay"]["v_down_port"])
my_relay.power_on()
my_relay.power_off()
my_relay.close()
except Exception, e:
print "{0} devivice has no relay - {1}!!!".format(serial, e.message)
s = d["serial"]
print "Prepare device " + str(s) + " for next build."
print "Will try to use adb connection to shutdown/put to sleep the device"
if local_utils.has_adb_serial(serial=s):
adb_steps.enable_uiautomator_service(serial=s, timeout=120)()
if shutdown_to_charge:
print str(s) + ": Shutdown device to charge"
local_steps.command(command="adb -s " + str(s) +
" shell reboot -p")()
time.sleep(5)
print str(s) + ": Shutdown - Done!"
else:
print str(s) + ": Put device to sleep"
adb_steps.put_device_into_sleep_mode(serial=s)()
print str(s) + ": Sleep - Done!"
else:
print str(s) + ": does not have adb connection!!!"
print str(s) + ": Try to use relay to shutdown the devices"
try:
my_relay = Relayed_device(relay_port=d["relay"]["tty"],
power_port=d["relay"]["power_port"],
v_up_port=d["relay"]["v_up_port"],
v_down_port=d["relay"]["v_down_port"])
my_relay.power_on()
my_relay.power_off()
my_relay.close()
except Exception, e:
print "NO relay!!!"
print e.message
########################################################################