# Parse command line parameters. sensor_args = { '11': Hema_DHT.DHT11, '22': Hema_DHT.DHT22, '2302': Hema_DHT.AM2302 } if len(sys.argv) == 3 and sys.argv[1] in sensor_args: sensor = sensor_args[sys.argv[1]] pin = sys.argv[2] else: print 'usage: sudo ./Hema_DHT.py [11|22|2302] GPIOpin#' print 'example: sudo ./Hema_DHT.py 2302 4 - Read from an AM2302 connected to GPIO #4' sys.exit(1) # Try to grab a sensor reading. Use the read_retry method which will retry up # to 15 times to get a sensor reading (waiting 2 seconds between each retry). humidity, temperature = Hema_DHT.read_retry(sensor, pin) # Un-comment the line below to convert the temperature to Fahrenheit. # temperature = temperature * 9/5.0 + 32 # Note that sometimes you won't get a reading and # the results will be null (because Linux can't # guarantee the timing of calls to read the sensor). # If this happens try again! if humidity is not None and temperature is not None: print 'Temp={0:0.1f}* Humidity={1:0.1f}%'.format(temperature, humidity) else: print 'Failed to get reading. Try again!' sys.exit(1)