# NXAPI init block
###################
target_url = "http://10.30.14.8/ins"
username = "******"
password = "******"
NXAPITransport.init(target_url=target_url,
username=username,
password=password)
###################
###################
# cli/clip/clid are changed a bit, but largely the same
###################
print NXAPITransport.cli("show version")
NXAPITransport.clip("show interface brief")
NXAPITransport.clic("conf t ;interface eth4/1 ;no shut")
print NXAPITransport.clid("show version")
###################
# Below is exactly the same as the usage on the switch. Do whatever you
# are already doing on the switch right now!
###################
print Interface.interfaces()
i = Interface("Ethernet4/1")
print i.show(key="eth_mtu")
###################
# NXAPI init block
###################
target_url = "http://10.30.14.8/ins"
username = "******"
password = "******"
NXAPITransport.init(target_url=target_url, username=username, password=password)
###################
###################
# cli/clip/clid are changed a bit, but largely the same
###################
print NXAPITransport.cli("show version")
NXAPITransport.clip("show interface brief")
NXAPITransport.clic("conf t ;interface eth4/1 ;no shut")
print NXAPITransport.clid("show version")
###################
# Below is exactly the same as the usage on the switch. Do whatever you
# are already doing on the switch right now!
###################
print Interface.interfaces()
i = Interface("Ethernet4/1")
print i.show(key="eth_mtu")
